Keyboard shortcuts

Press ← or → to navigate between chapters

Press S or / to search in the book

Press ? to show this help

Press Esc to hide this help

Build

The platform prints on a Bambu Lab A1, or any printer with a 256 mm bed, in about 680 g of PETG. There is nothing else to buy. It holds the Crimpdeq case from crimpdeq-case v2.0.0 or any earlier release.

Warning

Never load the platform above its 49 kg rating, and pull only with both clips and both keys fitted. Printed parts can fail: inspect them before each session and stop using any part that cracks or deforms.

Parts

The illustrations use the same colours throughout:

  • Base (grey), printed as a front and a rear half.
  • Anchor block (red) and finger grip (blue): their lugs go into the two eyes of the load cell.
  • Eye clips (yellow): hold the load cell down on the lugs.
  • Palm rest (orange) and index keys (green): set the hand opening.
  • Pocket stoppers (teal): make the 25 mm edge shallower.